Viking VUAR140 Troubleshooting Guide download pdf (Page 85)

Ice Maker Troubleshooting Chart ---VCBB Bottom Freezer - Refrigerator---

Incorrect heater temperature Replace mold and heater assembly

Apply alumilastic

Broken shut-off lever or Replace module

mislocated shut-off switch

3:00 Ejector Position

Contaminated Replace module

Jammed cubes Un-jam cubes

Notice size and density of cubes

Refrigerator or ice maker not level Level refrigerator or ice maker

No power to ice maker Determine discontinuity by tracing power

Excessive water-fill volume Adjust module screw, lower water pressure, or

replace water valve

Cubes falling back into mold during Replace fill cup

ejection Check fill tube assembly

4:00 Ejector Position

Contaminated Replace mold and heater assembly

Apply alumilastic

Thermostat out of calibration Replace thermostat. Apply alumilastic

Open heater circuit Replace mold and heater assembly

Motor should oscillate Apply alumilastic

Little or not alumilastic on thermostat Apply alumilastic to thermostat

Heater not staked in mold Replace mold and heater assembly

Apply alumilastic

Broken locking tabs on vertical cam Replace module

6:00 Ejector Position

Contaminated Replace mold and heater assembly

Apply alumilastic

Insufficient water to ice maker Refer to “Hollow Ice Cubes”

small or hollow cubes

7:30 Ejector Position

Contaminated Replace module

Motor will not oscillate

Shut-off arm stuck in ice or Remove obstruction

obstructed Replace module

Cubes not formed properly Un-Jam

Check fill cup and fill tube assembly

9:00 Efector Position

Contaminated Replace module

Cubes frozen to fill cup or mold Un-Jam

Replace fill cup and module

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 91 92

No comments

Viking VUAR140 Troubleshooting Guide Page 85