Viking VUAR140 Troubleshooting Guide download pdf (Page 64)

Program Mode – VCBB Bottom

Freezer – Refrigerator

Max Frz Run Time Duration

1. Press Max Frz pad. Max Frz light will

glow. One temperature indicator should

glow indicating present Max Frz run time

duration in 4 hour increments (indicator 1

means 4 hours, 2 means 8 hours, etc.)

Default delay is 24 hours.

2. Press Warmer pad to decrease Max Frz

duration by 4 hours.

3. Press Colder pad to increase Max Frz

duration by 4 hours.

Temperature Offset Calibration

Offset amount adjusts temperatures for refrigerator

cut ins and cut outs by the amount of offset. The

chart below shows the indicator and the amount of

offset from the factory default setting.

• Setting Refrigerator Temperature Offset.

Press Ref Temp pad. Refrigerator indicator

and one indicator will glow. Press Warmer

pad to move offset to the next warmer

setting. Press Colder pad to move to the

next colder setting. Factory default

refrigerator offset is +2.

• Setting Freezer Temperature Offset.

• Press Freezer pad. Freezer temperature

indicator and one indicator will glow. Press

Warmer pad to move offset to the next

warmer setting. Press Colder pad to move

offset to the next colder setting. Factory

default freezer offset is 0.

Default Mode Selection

Toggle * pad to select adaptive or conventional

defrost mode. Vacation indicator glows when

adaptive defrost has been selected. If vacation

indicator is off, conventional defrost is selected.

Conventional defrost uses 8 hour CRTD value.

Forced Defrost

Defrost can be forced to start by pressing and holding

the Alarm Off pad for 3 seconds. Program changes

will be saved permanently in EEPROM and program

mode will exit to Run Mode.

Forced Pull Down (Compressor Start)

Compressor start can be forced by pressing and

holding Max Frz for 3 seconds. Program changes

will be saved permanently in EEPROM.

Compressor, evaporator, fan, damper heater, and

condenser fan will come on.

Exiting Program Mode

Press Display On pad for 3 seconds to exit Program

Mode. Tone will sound three times. Changes made

in Program Mode will be permanently saved in

EEPROM.

Note: If no pad is pressed for 10 minutes, Program

Mode will be automatically exited. However , no

changes will be saved if Program Mode exits

automatically.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 91 92

Comments to this Manuals

No comments

Viking VUAR140 Troubleshooting Guide Page 64

Comments to this Manuals

Related products and manuals for Barbecues & grills Viking VUAR140