Viking Interlude 445 User's Guide download pdf (Page 14)

12

a

b

1

2

Learn your Interlude

Changing the Needle

!

Turn off the main switch.

1 Loosen the screw in the needle

clamp with the screwdriver.

2 Remove the needle.

3 Push the new needle upwards with

the ﬂ at side away from you until it

will go no further.

4 Use the screwdriver to tighten the

screw properly.

Changing the Presser Foot

!

Turn off the main switch.

1 Make sure that the needle is in the

highest position. Pull the presser

foot towards you.

2 Line up the cross pin on the foot

with the gap in the presser foot

ankle. Press back until the foot

snaps into place.

Presser Foot Pressure (a)

The presser foot pressure is adjusted

with the dial found under the lid on

your Interlude. Normal setting is around

four. The higher the number the more

pressure the foot puts on the fabric.

Knit and soft fabrics should be sewn at

lower pressure.

Presser Foot Lever (b)

The presser foot is raised and lowered

with the presser foot lever. The presser

foot must be lowered when sewing.

By raising the presser foot lever and

then press it upwards, the lift height of

the presser foot can be raised to extra

height in order to slide thick projects

under the foot.

Always use needles of system 130/705H.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Comments to this Manuals

No comments