Viking Designer Diamond User Manual download pdf (Page 4)

4 of 4

15. Watch your fabric and needle as you use the Control arrows to move the needle until it is

above the matching locked point of the design on your fabric.

16. Lower the needle into the upper flower section of the design to

check placement. Raise the needle. Adjust again using the Control

arrows. Continue to adjust until the needle is exactly above the

matching locked point.

17. Touch Zoom to Hoop.

18. Touch Step 3

19. Touch your screen to place the new red cursor on the lowest stem section of the design.

20. Touch and hold Zoom In all the way to the maximum

percentage.

21. Touch Pan then touch the screen and drag it up until you see the

red crosshair in the dark gray section of the screen as needed.

22. Touch Position then use the Control arrows to fine tune the

placement of the red crosshair to the exact point where the two sides

of the design will meet. Usually you will see long jump stitches in both

colors coming to one exact stitch point. That stitch point is exactly

where you want your red crosshair.

23. Touch Step 4 to rotate the design into position on your

fabric if necessary. Watch the needle above the fabric as you

adjust the control arrows.

24. Lower the needle into the lowest stem section of the design to

check placement. If the needle does not go into the exact selected

stitch point on the first half of the design, use the stylus or

Control arrows to rotate the design into the exact position. When

satisfied with placement, touch

25. Touch Zoom to Hoop

to see the entire design.

26. Press and embroider out the second side.

1 2 3 4 5 6 7 8 9 ... 89 90

No comments

Viking Designer Diamond User Manual Page 4