Viking Platinum 16 User's Guide download pdf (Page 8)

8

2. Install remaining end of controller

charging cable into the controller as

shown in Figures 4 & 5.

Figure 5. Charging cable installed.

Note at on cable is up.

Figure 4. USB Mini-B style

charging port on the TruStitch™

Controller.

3. With the machine and TruStitch™

controller turned off, install the

machine interface cable connector to

the machine foot pedal port (Figure

6). Secure the connector by turning

the screw shafts (Figure 7).

Figure 6. Figure 7.

4. The TruStitch™ receiver may

sit on top of the table or on the

shelf below the table. It may also be

attached to the machine using the

Velcro® strips provided, to secure it

to the side of the control or power

pod.

5. Plug the power module into a

power outlet and turn units on in the

following order:

1. Machine

2. TruStitch™ receiver

3. TruStitch™ controller

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments