Viking Emerald 183 Owner's Manual download pdf (Page 18)

3.14. Threading the upper thread

Make sure the presser foot is raised and the needle is in the up position.

Turn off the main switch.

1. Pull up the spool pin. Place a spool cap and then the thread

on the spool pin. Place the second spool cap on the spool

pin (A). Push the spool pin back in.

2. Bring the thread in the direction of the arrow under the

thread guide (B) so that the thread snaps into place. Then

bring the thread under the second thread guide (C).

3. Bring the thread down between the thread tension discs D.

4. Continue threading by drawing the thread up into the slot

on the take-up lever E from the right to the left.

5. There are two thread guides close to the needle: F and G.

Insert the thread into the two thread guides.

6. The needle is threaded from front to back. The white on the

presser foot ankle makes it easy to see the eye of the needle.

See needle threader instructions on the next page.

7. Place thread under the presser foot and into the thread

cutter where it is cut.

3.15. Cutting the thread

When you are finished sewing, you can cut the thread by raising

the presser foot and drawing the threads to the left side of the

machine and cut them using the thread cutter.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 54 55

No comments

Viking Emerald 183 Owner's Manual Page 18