Viking Huskylock 936 User's Guide download pdf (Page 70)

—66—

Finish

Stitch selection

Bias Tape Binding Foot (Option)

(Included in optional Huskylock 936 Cover

Stitch Kit, Part number: 412 6716-01)

Bias Tape Binding Foot

1. Press the stitch selection button until “Auto

M” “Cover stitch wide” appears. (Illus. A)

2. Press the fabric selection button until appro-

priate fabric type appears.

Note: Use needle A & E.

3. Raise the presser foot and snap on Bias Tape

Binding foot.

4. Trim off the two top corners. (Illus. B)

Note: 1”-11/4” (25-28 mm) width tape can be

used.

5. Insert the tape into tape guide. Use tweezers

to feed the tape through slot on front of foot.

6. Extend tail of bias tape 2” (5 cm) behind foot.

(Illus. C)

7. Lower presser foot and sew bias tape only to

test stitch.

8. Raise presser foot and insert fabric from the

left side of tape guide until edge of fabric lays

against pressed edge of bias tape. (Illus. D)

9. Lower presser foot and sew bias tape along

edge of fabric.

Hint: Hold tail of bias tape at back of foot to

guide until fabric is under needles.

Cut

Tape Guide

Bias Tape

Binding Foot

5cm

12-14

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 76 77 78

No comments

Viking Huskylock 936 User's Guide Page 70