Viking Huskylock 936 User's Guide download pdf (Page 39)

—35—

A.

B.

C.

Right side of fabric

Adjusting screw

Material guide

4-6. Flatlock

There are two ways to sew a ﬂ atlock stitch, with

wrong sides folded together to create a decora-

tive look and with right sides folded together to

create ladder stitch as used for lingerie.

1. Fold the material with wrong sides together.

Then raise the presser foot, set the material

so that it is under the needle, and then lower

the presser foot. Set the stitch width control

dial to (5-7). Sew, allowing the thread to loop

off the edge (C).

4. Pull the material open (ﬂ at) as shown. This

method is not recommended for thin materi-

als. To adjust the position of the material

guide, the same piece of material can be

used to make a test sewing.

Note: For use of decorative threads in looper,

decrease looper tension experiment,

and program your settings in one of the

memories for future use.

Flatlock with multipurpose foot:

2. Adjust with the adjusting screw so that the

needle moves down to a position 2.5~3.0 mm

(0.1~0.12 in.) inside the folded edge of the

material so that some of the stitching loops

over the edge.

3. While guiding the material with your hand,

sew at a constant speed.

Note: This foot will make it easier to sew along

the folded edge without cutting the fabric.

2.5~3mm

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 77 78

Comments to this Manuals

No comments