Viking VCBB5363ELSS Installation Manual download pdf (Page 14)

14

General Information

Area Requirements

Verify the following:

• Unit can ﬁ t into residence and can be

moved around corners and through

doorways.

• Floors can support unit’s weight plus

food weight (approximately 1200 pounds

[540 kg] per unit).

• Floors underneath refrigerator are level

with surrounding ﬁ nished ﬂ oor.

• Rear wall is solid and is able to support

two horizontally mounted 2 x 4s (included)

bolted to two wall studs. The 2 x 4 board

bolt heads must be ﬂ ush with 2 x 4 to

prevent obstruction.

• Remove anything attached to rear or side

walls that can obstruct unit installation.

• Cutout dimensions are accurate.

• Electrical outlet is in correct location.

• Water line is in correct location.

• DO NOT install a refrigeration unit near

a heat source, nor in a location where the

surrounding temperature will fall below

60º F (16º C).

Electrical Requirements

It is the customer’s responsibility to:

• Contact a qualiﬁ ed electrical installer.

• Assure that the electrical installation is

adequate and in conformance with

the National Electrical Code, ANSI/

NFPA 70-latest edition or Canadian

Electrical Code C22.1-1998 and C22.2

No. 0-M91 (or latest edition), and all local

codes and ordinances.

A 115 volt, 60-Hz, 15 amp, fused, electrical

supply is required. It is required that a

separate circuit serving only this appliance

be provided. This appliance is equipped

with a power supply cord having a 3-prong

grounding plug. To minimize possible

shock hazard, the cord must be plugged

into a mating 3-prong, grounding-type wall

receptacle. DO NOT use an extension cord.

If codes permit a separate grounding wire

to be used, it is recommended that a

qualiﬁ ed electrician determine that the

grounding path is adequate.

DO NOT ground to a gas line. Check with a

qualiﬁ ed electrician if you are not sure if the

appliance is properly grounded. DO NOT

have a fuse in the neutral or grounding

circuit.

Anti-Tip Requirements

The anti-tip boards should be fastened

into position prior to moving the unit into

the opening.

Note: Additional mounting boards may

be required if the unit does not touch

the back wall of the enclosure. To prevent

unit from tipping forward, it must be secured

in place with a solid sofﬁ t or wood block.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments