Viking VDWU524SS Installation Guide

VDWU524SSVDWU524WSSSFDWU524WSFDWU524VDWU324SSFDWU324InstallationGUIDE

8USA NOTICE :• Make sure the dishwasher is plumb and notice dishwasher can be placed with a small clearance under the counter top.• Turning the scre

9USA6.5 PREPARING THE WATER CONNECTION (A)Install an easily accessible shut-off valve (not supplied) in the water supply line. All solder connections

10USA NOTICE :• Either one of the methods below must be used or the dishwasher will not operate properly.• A hose that attaches to a sink spray can

11USA6.7 STEAM PROTECTION FOILSteam will form inside the dishwasher during operation. At the end of the cycle, when the dishwasher door is opened, it

12USA7. PLACEMENT OF DISHWASHER INTO THE OPENINGNow place the dishwasher into the opening and get ready to connect all hoses and electrical connection

13USA7.1.2 WATER SUPPLY CONNECTIONWater supply may be connected to the dishwasher in one of two ways:• With metal braided hose.• With copper tubing.

14USA7.3 ADJUSTING THE MOVABLE TOE KICKNow that you have successfully installed the dishwasher, you need to attach the toe kick to the dishwasher. The

15USAOpen locking tab on the Toe Kick(p). (A)Place it on the slots, which are on the brackets fixed before, and adjust the height - max. 1½" (38 m

16USA7.4 FIXING THE CABINET TO THE COUNTERy

17USA7.5 PREPARING THE CUSTOM DOORX = ?X==Mid. Point==Mid. PointHeight (h) : Height of the wooden door 30” (760mm) Width (w) : 23 ¼” to 23 ½” (592m

INTRODUCTION 11. IMPORTANT SAFETY INSTRUCTIONS 11.1 INSPECT THE DISHWASHER 22. TOOLS WHICH MAY BE NEEDED 33. MATERIALS WHICH MAY BE NEEDED 34. MAT

18USA127.6 PREPARING THE CUSTOM DOOR(t)

19USA123412345123457.7 INSTALLING THE CUSTOM DOOR7.8 FIXING THE CUSTOM DOOR

20USA7.9 FIXING THE CUSTOM DOOR7.10 ADJUSTING THE KICK PLATE• Check whether the bottom of the door (A) hits the kitchen cabinet base (B) .• If the d

21USAPLQǩ´FPaǬ´FPaǩ´FPaǬ´FPPLQ´FPPD[´FP1234c12121243PLQò´FPPD[´FPPLQ

22USA8. INSTALLER CHECKLISTYour installer must have completed and checked the following:• The dishwasher is square and level.• The dishwasher is fas

23USAIf service is required, call your authorized service agency. Have the following information readily available. • Model number • Serial number

Viking Range, LLC111 Front StreetGreenwood, Mississippi 38930 USA(662)455-1200For product information,call 1-888-845-4641or visit our web site in the

1USAINTRODUCTIONPlease read this installation manual and particularly the safety instructions completely and carefully. They will save you time and ef

2USAelectrical overload. The dishwasher is designed for an electrical supply of 120 V (volts), 60 Hz (hertz), AC, connected to a dishwasher-dedicated,

3USA2. TOOLS WHICH MAY BE NEEDEDFlat head Screwdriver3. MATERIALS WHICH MAY BE NEEDED(Additional materials may be required to comply with local codes)

4USA4. MATERIALS SUPPLIED4.1 PARTS SUPPLIEDParts for your dishwasher will come in several plastic bags. Check your parts bags shown to make sure you h

5USA5. DISHWASHER SPECIFICATIONS 5.1 TECHNICAL FEATURESPermissible water pressure 4.35 - 145 psi (0.3 - 10 bars) Electrical connection 120 V (volts),

6USA6. ENCLOSURE PREPARATION6.1 ELECTRICAL PREPARATION WARNINGThe dishwasher is designed for an electrical supply of 120 V, 60 Hz, AC, connected to a

7USATighten the plugs on both sides of your machine (v)Place the two mounting brackets into the top corners of the dishwasher.Fix the mounting bracket