Viking 15" (38.1 cm) Installation Guide download pdf (Page 6)

1110

AIR FLOW

The machine takes in room temperature air at the lower right front

and forces warm air out the lower left front. Restricting the airflow

ill adversely affect the ability of the ice machine to make ice.

ilters and Treatment

In general, it is always a good idea to filter the water. A water filter,

if it is of the proper type, can remove taste and odors as well as

particles. Some methods of water treatment for dissolved solids

include reverse osmosis, and polyphosphate feeders.

RO Water

This machine can be supplied with Reverse Osmosis water, but the water conductivity must be no less than 10

microSiemens/cm. A reverse osmosis system should include post treatment to satisfy the R.O. water’s potential

aggressiveness. Deionized water is not recommended.

Because water softeners exchange one mineral for another, softened water may not improve water conditions when

used with ice machines. Where water is very hard, softened water could result in white, mushy cubes that stick together.

If in doubt about the water, contact a local point of use water specialist for recommendations on water treatment.

Air

intake

Warm

air out

SPECIFICATIONS

DRAIN/ELECTRICAL LOCATION

GENERAL INFORMATION

Drain

Flexible tubing

3/8” ID pump model (included)

5/8” ID x 7/8” OD gravity model (not included)

Potable water inlet

1/4” compression fitting

3-1/4”

(8.3 cm)

2-1/2”

(6.4 cm)

1-1/2” (3.8 cm)

3-3/4”

(9.5 cm)

7-3/8”

(18.9 cm)

115V

power cord

1 2 3 4 5 6 7 8 9 10

No comments

Viking 15" (38.1 cm) Installation Guide Page 6