Viking DLE-300 Installation Manual download pdf (Page 26)

The information contained herein is proprietary to Lencore Acoustics Corp. and copyright protected. No part of this manual can be

copied, used or distributed without prior authorization from Lencore Acoustics Corp.

-22-

1. First, run power cables to the IN/OUT connections of each OP, taking care to be

consistent with positive and negative screw terminals.

Do NOT cross positive and negative connections while wiring power-

irreversible damage will occur.

2. Run the power cables (NOT LIVE) from the power supply unit in the electrical/IT

closet to the power +/- screw terminal connections of the first OP.

3. Complete all other wiring (audio and data) and perform wiring checklist (see page

35) BEFORE powering up the system.

WARNING

NOTE: Make sure that grounds are connected to grounds

and positives to positives, and that wires are not crossed

anywhere in the entire system. Double check the wiring

at each power supply.

Follow all labeling for power.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

No comments

Viking DLE-300 Installation Manual Page 26