Viking Combination Beverage Center/Ice Maker Installation Guide download pdf (Page 4)

ATTACHING THE OVERLAY PANEL TO THE DOOR

1. If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove

the door by angling the door off of the bottom hinge pin.

2. Peel back the door gasket to expose the screw holes.

3. Set the overlay panel flush to the front of the door in the desired location. Clamp the overlay panel to the door if

necessary.

4. Insert the wood screws through the back of the door into the pilot holes in the overlay panel and tighten.

5. Reinstall the door gasket by pressing into the door channel. Make certain the corners are inserted fully.

6. Install the door to the unit. Use the supplied plastic washer as shown in the figure below.

7. Realigning the door may be necessary. Any final door adjustments can be made using a 1/8” allen head driver to

adjust the door’s brackets. (See figure below)

8. Attach the door light striker plate as shown using the 5/16” hex or phillips head screws provided. Make certain the

light is able to turn on and off when the door is opened and closed.

9. Attach the door to the unit by reversing step number 1 above.

Magnetic door

gasket

Bottom of door

Attached overlay

panel

3/8” clearance

holes for

frame wood

screws -

10 holes

1/8” allen head screws for hinge

adjustment

Door hinge

adjustment screws

Door light striker plate

CAUTION

Door can become

disengaged if washers

are not installed.

CAUTION

Door can become

disengaged if

washers are not

installed.

Cabinet

Hinge

Overlay

Panel

Door Hinge

Shoulder bushing

3/4” OD x 7/16”

ID Washer

3/4” OD x 1/4” ID

Washer

(3) Nylon hardware

components at

bottom hinge

CAUTION

Door may not swing properly

if all nylon components are

not installed as shown

Bottom Hinge Cover

Overlay

Panel

Hinge Hardware Installation

Details

5/8”x 7/32” ID washer

Shoulder

bushing

(2) Nylon

hardware

components at

top hinge

Top Hinge Cover

Rear of Door

SELECTING AND PREPARING THE OVERLAY PANEL

FOR A 3-1/2” TOE KICK

(COVERS THE ENTIRE DOOR EXTRUSION)

Min. 5/8” (1.7 cm)

Max. 3/4” (1.9 cm)

23-3/4” (60.3 cm)

17-15/16” (45.6 cm) TYP

5-13/16” (14.8 cm)

23/32 “ TYP

1/4” x 3/8” Deep hinge screw clearance hole. Locate and drill using door

hinge hole after the door has been aligned to the unit and when the wood

is positioned on door.

Mounting surface (non-face) side

1/4” x 3/8” Deep hinge screw clearance hole. Locate and drill using door hinge hole

after the door has been aligned to the unit and when the wood is positioned on door.

Mounting surface (non-face) side

13/16” TYP

Both Sides

5-23/32”

(14.6 cm)

TYP

15-5/32”

(38.5 cm)

TYP

24-1/2”

(62.2 cm)

TYP

Pre-drilled pilot holes

10 places

30-5/16”

(77.0 cm)

TOP

DOOR

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Viking Combination Beverage Center/Ice Maker Installation Guide Page 4

Comments to this Manuals

Related products and manuals for Ice cube makers Viking Combination Beverage Center/Ice Maker