Viking VCBB363 Specifications download pdf (Page 33)

WATER CONNECTION

•Refer to water supply requirement section for preliminary installation and site preparation (see page7 ).

••DDoo nnoott uussee ppllaassttiicc wwaatteerr lliinneess bbeettwweeeenn rreeffrriiggeerraattoorr aanndd ssuuppppllyy.. PPllaassttiicc wwaatteerr lliinneess ccaann ffaaiill dduuee

ttoo ffaattiigguuee oovveerr ttiimmee

aanndd ccaauussee eexxtteennssiivvee ddaammaaggee ttoo pprroodduucctt aanndd tthhee hhoommee..

••UUssee oonnllyy 11//44"" ccooppppeerr ttuubbiin

ngg ffoorr wwaatteerr lliinnee..

•The installation of Viking refrigerator with an reverse osmosis system is acceptable

aass lloonngg aass tthhee wwaatteerr pprreessssuurree

rreemmaaiinnss wwiitthhiinn tthhee aalllloowwaabbllee PPSSII aass ssttaatteedd oonn ppaaggee 77..

It is important to note that with many reverse osmosis systems,

the pressure starts off high, but then it decreases as the water level of the reverse osmosis storage area drops. This

must be considered when checking the water pressure coming into the unit.

The 1/4" brass compression union is located in the literature packet.

1. Pull copper supply tubing from plumbing forward from underneath unit (see Figure A).

2. Flush air and impurities from water line by turning on water supply and running two (2) quarts (1.9 L) of water into a

bucket.

3. Bend the open end of the supply tube to point toward the open end of the Water Valve Tube (see Figure B). Note:

The Water Valve Tube is designed to flex or bend as necessary to line up with the supply tube, so union can be

connected easily.

4. Remove brass nuts and ferrules from union and slide onto open ends of Water Valve Tube and supply tubing (see

Figure C).

5. Connect nuts on copper tubing to union (see Figure D). Be sure both nuts are fully seated in union before tightening

nuts. Do Not over tighten.

6. Turn on water supply to unit and check for leaks.

7. Turn off water supply to unit and correct any leaks. Repeat this process until no leaks exist.

8. Completely turn on water supply to unit.

9. Verify drain pan is installed and aligned. Drain pan must be pushed past and over initial stopping point.

Figure A

Figure B

Copper tubing

Water valve tube

Figure D

Figure C

Brass nuts and

ferrules

1 2 ... 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Viking VCBB363 Specifications Page 33

Comments to this Manuals

Related products and manuals for Fridges Viking VCBB363