Viking Professional VCFF136SS Installation Guide download pdf (Page 13)

2524

Pull on tubing to confirm connection is secure.

Connect tubing to frame with tubing clamp.

Turn on water supply. Check for leaks and correct if

necessary. Monitor water connection for 24 hours. Correct

leaks if necessary.

Slide brass nut over sleeve and screw nut into inlet

port. Place adjustable wrench on nut attached to plastic

waterline and maintain position.

Using second adjustable wrench, turn the lower nut

counterclockwise and fully tighten the upper nut in

place. IMPORTANT: Do not overtighten. Cross

threading may occur.

Remove toe grille. Grasp firmly and pull outward

to unclip.

To raise the front of the unit, turn the leveler foot screw

clockwise. NOTE: Having someone push against the top

of the refrigerator takes some weight off the leveler foot

screws.

To lower the front of the unit, turn the leveler foot screw

counterclockwise. NOTE: It may take several turns of the

leveler foot screw to adjust the tilt of the refrigerator.

Replace toe grill. Align the toe grille mounting clips

with the lower cabinet slots. Push the toe grille firmly

until it snaps into place. Check for level.

Leveling

To protect property and refrigerator from damage, observe the following:

• Protect vinyl or other flooring with cardboard, rugs, or other protective material.

• Do not use power tools when performing leveling procedure.

Materials Needed

• 1/4” hex head driver

• Carpenter’s level

To enhance the appearance and maintain performance, the refrigerator should be level.

NOTE: Complete any required panel installation and/or water supply connection before

leveling. Refrigerator should be in permanent location prior to leveling.

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Viking Professional VCFF136SS Installation Guide Page 13