TECHNICAL DATA
January 12, 2007
Firecycle 427a
FIRECYCLE® III
MULTI-CYCLE DELUGE
SYSTEM
The Viking Corporation, 210 N Industrial Park Road, Hastings MI 49058
T
elephone: 269-945-9501 T
echnical Services 877-384-5464 Fax: 269-945-4495 Email:
[email protected]Revised page replaces page 427 a-d dated March 16, 2004
(Revised Format, added “Multi-Cycle”)
Form No. F_081596
1. DESCRIPTION (Refer to Figures 1 and 2)
The Viking Firecycle® III Multi-Cycle Deluge System utilizes a Viking Model H or J Flow Control Valve (A.1) and a Firecycle® III Control
Panel (E.3) with additional valves, devices, and trim to form a unique operating system.
to minimize water usage, water damage, and the danger of pollution to surrounding areas.
is manually shut-off.
Refer to Section B “System Operation” for details.
the system when the system operates. Consult all Authorities Having Jurisdiction prior to installing a Firecycle® III Multi-Cycle DelugeFirecycle® III Multi-Cycle Deluge
System. The Firecycle® III Multi-Cycle Deluge System requires use of a Viking Flow Control Valve and trim kit with two electric Release. The Firecycle® III Multi-Cycle Deluge System requires use of a Viking Flow Control Valve and trim kit with two electric ReleaseFirecycle® III Multi-Cycle Deluge System requires use of a Viking Flow Control Valve and trim kit with two electric Release requires use of a Viking Flow Control Valve and trim kit with two electric Release
NOTE: FIRECYCLE® III IS A COMPLETE SYSTEM, AND IS LISTED AS A UNIT. AS SUCH, IT IS NORMALLY NOT POSSIBLE TO MODIFY
THE COMPONENTS OF THE SYSTEM CONTROLS OR THEIR INTER-RELATION WITHOUT COMPROMISING THE LISTING.
2. LISTINGS AND APPROVALS
UL Listed - Category VLLA
FM Approved - On-Off Multi-Cycle Sprinkler Systems
4. INSTALLATION
-
-
or mechanical damage.
of the Viking Firecycle® III System.
Placing the System In Service (Refer to Figures 1 and 2)
NOTE: REFER TO FIRECYCLE® III OWNER’S MANUAL AND INSTRUCTIONS PROVIDED IN TECHNICAL DATA DESCRIBING THE
VIKING FLOW CONTROL VALVE AND OTHER SYSTEM COMPONENTS.
according to instructions provided in Viking Technical Data and the Firecycle® III Owner’s Manual.
current Viking Trim Charts and schematic drawings for the system used.
priming line is pressurized up to the closed Priming Valve (B.1).
Open the Priming Valve (B.1).
Reset the Firecycle® III Control Panel (E.3) (Open panel and press “RESET”.) Release Solenoid Valve #1 (E.1) should close.
Flow from Release Solenoid Valve #1 (E.1) to Drain Cup (B.14) should stop.
Open the Flow Test Valve (B.15).
System Drain (D.3).
Close the System Drain (D.3).
1.
2.
3.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
edition of this Technical Data Page.
Comments to this Manuals