20 21
Reattach door to range.
Open door completely. Reattach hinge trim.
Remove pins from hole in hinges.
Close door.
If the door needs to be adjusted, loosen hinge trim screws located in
step 2. Adjust the screws located between the door and kickplate using a
5/32” hex head allen wrench. After adjustment, tighten hinge trim screws.
Door Replacement and Adjustment
Install island trim. Attach with four screws provided.
Burner caps are packed in styrofoam top pack with the grates.
Place burner on top of range. Place burner grate on top of burner
cap and grate support.
Note: Arrow on burner cap must be pointing towards back of range.
4
3
/
8
”
3/8”
(
0
.
9
5
c
m
)
(0.95 cm)
3
/
8
”
(
0
.
9
5
c
m
)
Check that unit is level side to side
and front to back. The side trim must be 3/8” (0.95 cm)
above countertop. If unit is not level repeat steps 5-7
of “Leveling/Adjustments/Alignment” section.
Slide range into place. Be sure
anti-tip bracket slides into the anti-tip opening.
Final Installation
Standoff Bracket Removal
FIRE HAZARD
Backguards come standard with
standoff brackets which provide
a barrier between back of range
and rear wall. These must be in place for
adequate ventilation. The standoff brackets
may only be removed if range is installed
against a non-combustible wall.
Note: Standoff brackets can only
be removed if range is installed
against a NON-COMBUSTIBLE
wall. Please see the backguard
install guide for instructions on
how to remove the standoff
brackets.
Comments to this Manuals