Viking VWD527SS Use and Care Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
10
Service Information
If service is required, call your authorized service agency.
Have the following information readily available.
• Model number
• Serial number
• Date purchased
• Name of dealer from whom purchased
Clearly describe the problem that you are having. If you are unable to obtain the name of an authorized service agency, or if you
continue to have service problems, contact Viking Range, LLC at1-888-845-4641, or write to:
Viking Range, LLC
PREFERRED SERVICE
111 Front Street
Greenwood, Mississippi 38930 USA
Record the information indicated below. You will need it if service is ever required. The model and serial number for your warming
drawer Rating/Serial plate is located on the left, rear side.
Model no. _________________________________________Serial no. __________________________________________
Date of purchase ___________________________________Date Installed ______________________________________
Dealers name ________________________________________________________________________________________
Address _____________________________________________________________________________________________
____________________________________________________________________________________________________
If service requires installation of parts, use only authorized parts to insure protection under the warranty.
Material Recommendations
Drawer interior (stainless steel) Use dish detergent. Wash, rinse well and dry. For hard water spots or scales, use white
vinegar. Apply with a sponge or cloth, rinse, and dry.
Heat Discoloration / Corrosion:
Clean with BarKeepers Friend® sprinked on a wet sponge or wet cloth. Apply to stainless
steel surface. Rub gently and evenly in the direction of the grain. Rinse and dry.
Painted Surfaces Use hot soapy water or mild non-abrasive cleaners. Wash, rinse well and dry. Avoid using
abrasive cleaning agents, steel wool pads and oven cleaners. These could damage the
painted surface.
Drawer exterior (stainless steel) Always wipe or rub in the direction of the grain. Clean with a soapy sponge, then rinse and
dry or use mild non-abrasive cleaners on a paper towel. Protect and polish with stainless
steel cleaner and a soft cloth. Remove water spots a cloth dampened with white vinegar.
Control Panel Clean with hot soapy water or mild non-abrasive cleaner on a clean sponge. Wipe clean.
Avoid usng abrasive cleaners and scrubbing pads.
Glass Surfaces Use hot soapy water or mild non-abrasive glass cleaners with a soft cloth. Wash, rinse well
and dry. Avoid using abrasive cleaning agents and scrubbing pads. This could scratch the
glass surface.
Cleaning Chart
Page view 9
1 2 ... 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments