Viking MVSOE630SS Installation Guide download pdf (Page 10)

Site Preparation

Note: It is recommended that a thorough site inspection be conducted PRIOR to unpacking and moving this appliance.

• Con rm available access to adequate power—see electrical requirements.

° Single oven units require a 30 amp circuit

° Double oven units require a 50 amp circuit

•Note: A minimum of 2” spacing above and below the oven to any adjacent items is required for ventilation purposes.

•It is recommended that 3/4” or thicker material be utilized to create a support platform for this appliance.

• BE SURE that support for this appliance is perpendicular to the front facing of the wall or cabinet before you perform the

installation.

•Use of a hydraulic lift is recommended for the installation of double oven units. Be careful not to bend lower trim/vent.

•All openings in the wall behind the appliance or in the  oor under the appliance should be sealed.

•Keep appliance area clear and free from combustible materials, gasoline and other  ammable vapors.

Remove wooden brace on front of pallet.

Open door completely. Rotate door hinge to

unlocked position.

Installation

General Information

3 4

Close the door until it stops. Push in/lift door up/and then out. Repeat for all

doors.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Viking MVSOE630SS Installation Guide Page 10