Viking FDFB5303L Installation Manual Page 1

Installation Guide5 SeriesCustom PanelAll Refrigerator/All Freezer

9”(22.9 cm)73-3/8”(186.4 cm)82-7/8”(210.5 cm) min.anti-tip board &opening height84-1/16”(213.5 cm) max.anti-tip board &opening height36”(91.5

One 2”x 4” mounting board1-1/2” (3.8 cm) x 3-1/2” (8.9 cm)Note: If unit is installed deeper than 24” (61.0 cm), then shim behind the mounting boards b

23-3/16”(58.9 cm)24-3/4”(62.9 cm)Measurement varies(locally supplied hardware)30”(76.2 cm)29”(73.7 cm)75-15/16”(192.9 cm)3-1/2”(8.9 cm)30”(76.2 cm)29”

75-15/16”(192.9 cm)3-1/2”(8.9 cm)30”(76.2 cm)29”(73.7 cm)29-1/2”(74.9 cm)1”(2.54 cm)between units35”(88.9 cm)36”(91.5 cm)Measurement varies(locally su

75-15/16”(192.9 cm)3-1/2”(8.9 cm)1”(2.54 cm)between units35”(88.9 cm)36”(91.5 cm)Measurement varies(locally supplied hardware)23-3/16”(58.9 cm)24-3/4”

Specifications 15Dual All Refrigerator/Freezer*Description (2) 30” Units (1) 36” & (1) 30” Unit (2) 36” UnitsOverall width 60” (152.4 cm) 66” (1

9”(22.9 cm)73-3/8”(186.4 cm)82-7/8”(210.5 cm) min.anti-tip board &opening height84-1/16”(213.5 cm) max.anti-tip board &opening height60”(152.4

79-3/8”(201.6 cm) min.to bottom of anti-tip board80-1/2”(204.6 cm) max.to bottom of anti-tip boardOne 2”x 4” mounting board per unit1-1/2” (3.8 cm) x

9”(22.9 cm)73-3/8”(186.4 cm)82-7/8”(210.5 cm) min.anti-tip board &opening height84–1/16”(213.5 cm) max.anti-tip board &opening height66”(167.6

79-3/8”(201.6 cm) min.to bottom of anti-tip board80-1/2”(204.6 cm) max.to bottom of anti-tip boardOne 2”x 4” mounting board per unit1-1/2” (3.8 cm) x

2Table of ContentsWarnings & Important Information ____________________________________________________________________3All Refrigerator/FreezerDi

9”(22.9 cm)73-3/8”(186.4 cm)82-7/8”(210.5 cm) min.anti-tip board &opening height84-1/16”(213.5 cm) max.anti-tip board &opening height72”(182.9

79-3/8”(201.6 cm) min.to bottom of anti-tip board80-1/2”(204.6 cm) max.to bottom of anti-tip boardOne 2”x 4” mounting board per unit1-1/2” (3.8 cm) x

35-1/4”(89.5 cm)75-1/2”(191.8 cm)3/4”(1.9 cm)29-1/4”(74.3 cm)75-1/2”(191.8 cm)3/4”(1.9 cm)Overlay Dimensions 2230” Custom Panels36” Custom PanelsNote:

1/2”(1.27 cm)1-1/2”(3.81 cm)1/4” Radius(.64 cm)2-3/4”(6.98 cm)1/2”(1.27 cm)3/4”(1.90 cm)1/2”(1.27 cm)1/8”(.31 cm)1/2”(1.27 cm)1/4” Radius1/4” Radius(1

2-1/8”(5.39 cm)3-1/8”(7.94 cm)3-5/8”(9.20 cm)1-3/8”(3.49 cm)3/8”(.95 cm)3/8” Radius3/8” Radius(.95 cm)(.95 cm)3/8” Radius(.95 cm)Reverse dimensions fo

Note: This part should be located at the center of the grille. If desired, two per grille can be used by dividing the length of the grille into thirds

Note: This part should be located at the center of the grille. If desired, two per grille can be used by dividing the length of the grille into thirds

Note: This part should be located at the center of the grille. If desired, two per grille can be used by dividing the length of the grille into thirds

28Top ViewTop ViewDoor24”(61.0 cm)standard cabinet depth25”(63.5 cm)countertopdepth25”(63.5 cm)countertopdepth25”(63.5 cm)countertopdepthWall3/4”(1.9

Top ViewFlush mount cabinet doors24”(61.0 cm)standard cabinetdepth24”(61.0 cm)standard cabinetdepth24”(61.0 cm)standard cabinetdepth24-3/4”(62.9 cm)Ca

3IMPORTANT – Please Read and Follow• Make sure that incoming voltage is the same asunit rating. An electric rating plate specifyingvoltage, frequency,

3/4”(1.9 cm)End panel1”(2.5 cm)1/4”(0.6 cm)Z-Bracket21-3/4”(55.2 cm)21-3/4”(55.2 cm)24”(61.0 cm)Optional kickplate notch(Dimensions determined by cabi

31Custom Panel General InformationCustom finishing options• All installations must allow for the refrigeratorand freezer door to open a minimum of 90˚

32Remove handle side cabinet screws and trim with a phillips screwdriver.Remove all screws from handle side door trim. Remove two screws from top and

517Slide custom wood panel to the hinge side, ensuring “Z” bracket engages the door bracket.8x13x2x2Reinstall handle side door trim and door trim scre

3412Remove air grille center blade.Remove two 1/4” (0.6 cm) screws with a magneticextended screwdriver at least 8” (20.3 cm) long.34Pull air grille as

35Install two 1/4” (0.6 cm) screws with a magneticextended screwdriver at least 8” (20.3 cm) long.Install custom air grille center blade.78Custom Gril

36General InformationArea RequirementsVerify the following:• Unit can fit into residence and can be movedaround corners and through doorways.• Floors

37General InformationWater Supply RequirementsUse only 1/4” (6 mm) copper tubing for water line.DO NOT install copper tubing in area wheretemperatures

38General Information• Most of the unit’s weight is at the top. Extracare is needed when moving the unit to prevent tipping. • DO NOT remove protectiv

3912Place unit in front of cutout.Pull the center grille louver up at an angle and pull out.34Using an 8” magnetic nut driver, remove the two 1/4” scr

IMPORTANT – Please Read and Follow!4A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local laws, orlocal ordinances.

40Replace unit top and four side screws.Attach one 2 x 4 to wall stud (refer to dimensions pagefor exact location).If needed, depending on cabinet and

4111Pull supply tubing forward under unit.Note: DO NOT use plastic water lines.1213Flush water line by running two quarts of water into a bucket. Turn

42Verify that drain pan is installed and aligned.Align holes on both ends of louvered panels and insert screws.Using a phillips screwdriver, attach th

43Replace top air grille.Using an 8” magnetic nut driver, replace the two 1/4” screws.Replace the center grille louver.Open door. The display should f

44Performance Checklist Verify cabinet size. Verify electrical supply and water supply (if applicable). Install anti-tip device(s) and verify unit

45Verify OperationsControl Panels1. Press “Activate Controls” pad.2. Verify unit is not in Sabbath Mode.If in Sabbath Mode:A. The Sabbath Mode will di

46Service & RegistrationIf service is required, call your dealer or authorized service agency. The name of the authorized serviceagency can be obt

47

Viking Range, LLC111 Front StreetGreenwood, Mississippi 38930 USA(662) 455-1200For product information, call 1-888-(845-4641)or visit our web site at

5ELECTRICAL SHOCKHAZARDDisconnect power or turnpower disconnect switch toOFF position before removing top grille.Failure to do so can result in death

24”(61.0 cm)35”(88.9 cm)75–15/16”(192.9 cm)3–19/32”(9.1 cm))36”36”(91.5 cm)(91.5 cm)36”(91.5 cm)9–5/32”(23.3 cm)82–3/4”(210.2 cm)min.to84–1/16”(213.5

7Specifications 30” All Refrigerator/FreezerDescription FDFB/CFDFB FDRB/CFDRBOverall width 30” (76.2 cm)Overall height (from bottom) 82-3/4” (210.2 cm

9”(22.9 cm)73-3/8”(186.4 cm)82-7/8”(210.5 cm) min.anti-tip board &opening height84-1/16”(213.5 cm) max.anti-tip board &opening height30”(76.2

One 2”x 4” mounting board1-1/2” (3.8 cm) x 3-1/2” (8.9 cm)Note: If unit is installed deeper than 24” (61.0 cm), then shim behind the mounting boards b