Viking VCWB300RSS Troubleshooting Guide download pdf (Page 8)

1514

Changing the Light Tube in the Top Zone

To change the light tube, first remove the center grille assembly and

turn the power ON/OFF switch to the OFF position (see page 9).

NOTE: Please contact your Viking Range Corporation parts distributor

or dealer to order new light tubes.

1. Remove the four screws from the lamp holder attaching the lamp

holder to the underside of the control panel.

2. Rotate the rear of the lamp holder down and forward then pull the

front tabs that engage into the control out of the control panel.

3. Set the lamp holder and screws to the side.

4. Pull the wires attached to the lamp tube through the hole in the

control panel and disconnect the wires attaching the lamp to the

cabinet wire harness.

5. The lamp tube is to be connected to one white wire and one

yellow/red wire.

6. Place tubes in lamp holder. Feed wires back into control panel and

reassemble in reverse order.

Control Panel

Changing the Light Tube in the Middle Zone

To change the light tube, first remove the center grille assembly and

turn the power ON/OFF switch to the OFF position (see page 9).

1. Remove the lamp wire cover by removing the two screws located on

the upper left side of the middle zone. (NOTE: ONLY REMOVE

THE TWO SCREWS HOLDING THE WIRE COVER; DO NOT

REMOVE SHELF MOUNTING SCREWS).

2. Set the wire cover and screws to the side.

3. Disconnect the lamp by disconnecting one yellow and one white

wire from each lamp.

4. Remove the clamp and screw located at the end of the lamp. The

lamp is located on the underside of the middle mullion shelf.

5. Carefully unsnap light tube from shelf and snap new light tube into

place.

6. Reassemble in reverse order.

Light

Clamps

Wire Cover

Screws

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Viking VCWB300RSS Troubleshooting Guide Page 8