Viking VUAR140 Specifications download pdf (Page 7)

Attaching the Wood Frame to the Door (DFUR MODEL)

1. If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove

the door by angling the door off of the bottom hinge pin.

2. Peel back the door gasket to expose the screw holes.

3. Set the wood frame flush to the front of the door in the desired location. Clamp the wood frame to the door if

necessary.

4. Insert the wood screws through the back of the door into the pilot holes in the wood frame and tighten.

5. Reinstall the door gasket by pressing into the door channel. Make certain the corners are inserted fully.

6. Install the door to the unit. Use the supplied plastic washer as shown in the figure below.

7. Realigning the door may be necessary. Any final door adjustments can be made using a 1/8” allen head driver to

adjust the door’s hinges. (See figure below)

8. Attach the door light striker plate as shown using the 5/16” hex or phillips head screws provided. Make certain the

light is able to turn on and off when the door is opened and closed.

9. Attach the door to the unit by reversing step number 1 above.

Magnetic door

gasket

Rear of Door

Bottom of door

Attached wood frame

3/8” clearance

holes for

frame wood

screws -

10 holes

1/8” allen head screws for hinge

adjustment

Door hinge

adjustment screws

Door light striker plate

Attaching the Handle

Attach the handle of your choice by drilling mountingholes through panel. Countersink or counterbore holes from back

side of panle for handle screw heads to be flush

CAUTION

Door can become

disengaged if washers

are not installed.

CAUTION

Door can become

disengaged if

washers are not

nstalled.

Cabinet

Hinge

Wood

Frame

Door Hinge

Shoulder bushing

3/4” OD x 7/16”

ID Washer

3/4” OD x 1/4” ID

Washer

(3) Nylon hardware

components at

bottom hinge

CAUTION

Door may not swing properly

if all nylon components are

not installed as shown

Bottom Hinge Cover

Wood Frame

HHiinnggee HHaarrddwwaarree IInnssttaallllaattiioonn

DDeettaaiillss

5/8”x 7/32” ID washer

Shoulder

bushing

(2) Nylon

hardware

omponents at

top hinge

Top Hinge Cover

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Viking VUAR140 Specifications Page 7

Comments to this Manuals

Related products and manuals for Barbecues & grills Viking VUAR140