Viking VGSO166 Specifications

INSTALLATIONINSTRUCTIONSVGSO166 BUILT-IN GAS OVENRetain for Future UseVIKING RANGE CORPORATION111 Front StreetGreenwood, Mississippi 38930 USA(662)453

10Infrared Broil Burner Conversion1. Remove two (2) screws holding the ignitor and let the ignitor hang down.2. Remove the broil burner brackets in

Initial Ignition of BurnersAll ovens are tested before leaving the factory. When the oven is connected to the gas supply and the electricalservice, t

Service CodesThe Time/Temperature digital display is designed to alert you if there is an error or problem in the control. If one ofthe following cod

2DescriptionCutout width 33 7/8” (86.0 cm)Cutout height 22 5/8” (57.5 cm)Cutout depth Minimum 24” (61.0 cm); unit extends into cutout 23 7/8” (60.6 cm

3WARNING!!ELECTRICAL GROUNDING INSTRUCTIONSThis appliance must be electrically grounded in accordance with local codes or, in the absence of codes, wi

4Dimensions•For double side-by-side installation, repeat single cutoutwith 1½” (3.8 cm) minimum between openings.

5•The grounded electrical socketshould be placed above orbelow the cutout(s).•Do not install so that any ovenvent (top grill of oven) is locatedbelow

DCT-VGSO-SS (Optional Center Trim ) Installation (See illustration below)A. Install mounting brackets (1) between the ovens on both sides.B. Insert

7Gas ConnectionThe gas supply (service) line must be the same size or greater than the inlet line of the appliance. This range uses a1/2” (1.3 cm) ID

8LP ConversionLP Conversion should be done before unit is installed in cabinet.RREEGGUULLAATTOORR CCOONNVVEERRSSIIOONN1. Remove the access panel on

9Gas Bake Burner AdjustmentsCheck the gas supply and set the regulator to the proper supply of gas. A properly adjusted burner should be stableand qu